Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
LN-7 GMA WIRE FEEDER
TROUBLESHOOTING AND REPAIR F-43
6. Place the idle roll assembly into the
groove pin. Secure in place with a
speed clip.
7. Slide the pivot pin into the swing arm
assembly. Place the flat washer and
swing arm assembly on the gearbox
assembly. Fasten in place with the hex
head bolt.
8. Swing the swing arm assembly in
toward the gearbox. Latch the swing
arm assembly by rotating the latch knob
towards the conductor block.
SWING ARM ASSEMBLY REPLACEMENT FOR
TWO-ROLL WIRE FEEDERS
(continued)