Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
REPAIR PROCEDURE
1. Remove the cover from the control box
by removing the four 5/16 in. screws
from the top and side of the unit.
2. Remove the retaining nut from the front
of the push button and remove the push
button from the control box. See Figure
F.5.
3. Unsolder the two leads from the back of
the push button.
4. Solder the two leads onto the new push
button.
5. Install the new push button through the
case of the control box.
6. Install the retaining nut onto the front of
the push button.
7. Reinstall the cover on the control box
using four hex head screws.
LN-7 GMA WIRE FEEDER
TROUBLESHOOTING AND REPAIRF-24
GROUND LEAD PROTECTOR
PUSH BUTTON SWITCH REPLACEMENT
(continued)