Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING AND REPAIR
LN-7 GMA WIRE FEEDER
F-16
CONTROL CABLE CONTINUITY TEST
Service and repair should only be performed by Lincoln Electric factory trained
personnel. Unauthorized repairs performed on this equipment may result in
danger to the technician or machine operator and will invalidate your factory
warranty. For your safety and to avoid electrical shock please observe all safety
notes and precautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to
perform the test/repairs safely, contact the Lincoln Electric service department
for technical troubleshooting assistance before you proceed. Call 216-383-2531
or 1-800-833-9353(WELD).
TEST DESCRIPTION
This test will determine if the control cable from the welding power supply to the wire
feeder is functioning properly. The test checks for continuity of each cable and for shorts
between cables.
MATERIALS NEEDED
Volt/Ohmmeter (Multimeter)
Wiring Diagrams, Figure G.1 - G.3.
WARNING