Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING AND REPAIRF-46
LN-7 GMA WIRE FEEDER
SWING ARM ASSEMBLY REPLACEMENT FOR
FOUR-ROLL WIRE FEEDERS
(continued)
7. Place the two swing arms and spacers
in the center post of the wire drive
assembly. Ensure the holes in the
pieces line up to accept the hinge pin.
Do not use excessive force when installing
the hinge pin. If hinge pin does not go in,
remove it and try again.
8. Slide the hinge pin into the hinge pin
opening in the center post. Use a
rubber mallet to drive the hinge pin in if
necessary. Drive the hinge pin in until
the detente in the pin is visible in the
setscrew hole.
9. Install the setscrew and tighten until
snug.
CAUTION