Filter
Top Products
OM-196 188 Page 115
1 Name Display
When a data card is used, the pro-
grams written from the unit to the
card can be named.
Memory
Shutdown
> Name
Program
Card
Programs
>On
Card
Programs
>Off
1
14-14. Selecting Program Name Feature
Press Mode
Select
Increase
Access
Setup
Display
14-15. Remote Program Select
1 Program Display
When Program is On, a remote
device or robot Teach Pendant may
be used to select programs (see
Section 14-16). When Off, program
selection must be done from Setup
Pendant.
Shutdown
Name
> Program
Jog IPM
Remote
Select
>Off
Remote
Select
>On
1
Press Mode
Select
Increase
Access
Setup
Display
14-16. Remote Program Setting
When Remote Program Select is “On”, program selection will be determined by
remote input once a weld is intiated. In “Standby” mode, program selection can be
done in a normal manner from the Setup Pendant.
NOTE
See the following table for the remote program select binary code.
Program No. Output A Output B Output C
1 Off Off Off
2 On Off Off
3 Off On Off
4 On On Off
5 Off Off On
6 On Off On
7 Off On On
8 On On On