Filter
Top Products
OM-196 188 Page 121
15-4. Setting Auto Configure Parameter
1 Auto Configure Display
Setting allows user to do manual
configuration or automatic
configuration by welding power
source/interface.
Use Increase or Decrease button to
change setting.
Press Mode Select button to go to
next parameter or cycle power off
and back on at power switch to sav-
e setting and exit Control menu.
1
Off
Arc On
No Analog
Inputs
Access
Control
Display
Increase/Decrease
>Process
Sequence
SharpArc
Card
> Prg 1
Pulse
035” Steel
Argon – Oxy
Rise Time
Adaptive
> AutoConfig
Retract
>On
None
Mode
Select
Go To
Section 15-5
Or
Power
Switch
Off
Arc On
& Analog
Inputs
Increase/Decrease
Off
PS, Wire,
Gas &
Analog
Increase/Decrease
Press Mode
Select