Filter
Top Products
Default Settings and Technical Specifications A-1
v1.0, September 2009
Appendix A
Default Settings and Technical Specifications
You can use the reset button located on the rear panel to reset all settings to their factory defaults.
This is called a hard reset (for more information, see “Reverting to Factory Default Settings” on
page 10-18).
• To perform a hard reset, press and hold the Reset button for approximately eight seconds (until
the TEST LED blinks rapidly). The UTM returns to the factory configuration settings that are
shown in Table A-1 below.
• Pressing the Reset button for a shorter period of time simply causes the UTM to reboot.
Table A-1 shows the default configuration settings for the UTM.
Table A-1. UTM Default Configuration Settings
Feature Default behavior
Router Login
User login URL https://192.168.1.1
Administrator user name (case sensitive) admin
Administrator login password (case sensitive) password
Guest user name (case sensitive) guest
Guest login password (case sensitive) password
Internet Connection
WAN MAC address Use default address
WAN MTU size 1500
Port speed AutoSense
Local Network (LAN)
Lan IP address 192.168.1.1
Subnet mask 255.255.255.0
RIP direction None
RIP version Disabled
RIP authentication Disabled