NETGEAR UTM25-100NAS Router User Manual


 
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
System Logs and Error Messages C-9
v1.0, September 2009
Traffic Metering Logs
This section describes logs that are generated when the traffic meter has reached a limit.
Unicast Logs
This section describes logs that are generated when the UTM processes unicast packets.
ICMP Redirect Logs
This section describes logs that are generated when the UTM processes ICMP Redirect messages.
Table C-13. System Logs: Traffic Metering
Message Jan 23 19:03:44 [TRAFFIC_METER] TRAFFIC_METER: Monthly Limit of
10 MB has reached for WAN1._
Explanation Logs that are generated when the traffic limit for WAN1 interface that was set at
10 MB has been reached. Depending on the setting that is configured in the
“When Limit is reached” section on the WAN1 Traffic Meter screen (see
“Enabling the WAN Traffic Meter” on page 11-1), all the incoming and outgoing
traffic might be stopped.
Note: For WAN2 interface, see the settings on the WAN2 Traffic Meter screen.
Recommended Action To start the traffic, restart the traffic counter in the “Traffic Counter” section on
the WAN1 Traffic Meter screen.
Note: For WAN2 interface, see the settings on the WAN2 Traffic Meter screen.
Table C-14. System Logs: Unicast
Message Nov 24 11:52:55 [UTM] [kernel] UCAST IN=SELF OUT=WAN
SRC=192.168.10.1 DST=192.168.10.10 PROTO=UDP SPT=800 DPT=2049
Explanation This unicast packet is destined to the device from the WAN network.
For other parameters, see Table C-1.
Recommended Action None
Table C-15. System Logs: Unicast, Redirect
Message Feb 2007 22 14:36:07 [UTM] [kernel] [LOG_PACKET] SRC=192.168.1.49
DST=192.168.1.124 PROTO=ICMP TYPE=5 CODE=1
Explanation This packet is an ICMP Redirect message sent to the device by another
device.
For other parameters, see Ta ble C-1.
Recommended Action None