Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Using the Setup Wizard to Provision the UTM in Your Network 2-27
v1.0, September 2009
Verify that the UTM properly scans HTTP traffic:
1. Log on to the UTM Web Management Interface, and then verify that HTTP scanning is
enabled. For information about how to enable HTTP scanning, see “Customizing Web
Protocol Scan Settings and Services” on page 6-19 and “Configuring Web Malware Scans” on
page 6-21.
2. Check the downloaded eicar.com test file, and note the attached malware information file.
Registering the UTM with NETGEAR
To receive threat management component updates and technical support, you must register your
UTM with NETGEAR. The support registration key is provided with the product package (see
“Service Registration Card with License Keys” on page 1-8).
Note: Activating the service licenses initiates their terms of use. Activate the licenses
only when you are ready to start using this unit. If your unit has never been
registered before you can use the 30-day trial period for all 3 types of licenses to
perform the initial testing and configuration. To use the trial period, do not click
Register in step 4 of the procedure below but click Trial instead.