Filter
Top Products
3.14 [1-1] Slot—Card Property - Virtual IP Extension
The properties of the V-IPEXT card can be specified.
Signalling (PTAP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPEXT card to transmit and receive PTAP (Panasonic Telephony
Administration Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1–65535
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Guide References
1.31.1 IP Proprietary Telephone (IP-PT)
Signalling (MGCP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPEXT card to transmit and receive MGCP (Media Gateway Control
Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1–65535
Maintenance Console Location
3.14 [1-1] Slot—Card Property - Virtual IP Extension
Programming Manual References
None
Feature Guide References
1.31.1 IP Proprietary Telephone (IP-PT)
Signalling (MGCP) UDP Port No. (IP-PT)
Specifies the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on the
IP-PT side. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
PC Programming Manual 173
3.14 [1-1] Slot—Card Property - Virtual IP Extension