Filter
Top Products
2.6.20 Utility—Card Software Timed Update
Updates programmes
in the LPR cards (optional service cards with local processors) by comparing them with
files found on the SD memory card on a preset schedule, and downloading newer files to the cards.
This option is only available at Installer level.
Note
• Timed updates
can only be set for either LPR cards, IP-CSs, or KX-NT400 IP-PTs. They cannot be set
for more than one type of device.
• Cards are automatically set to OUS status during an update, and returned to INS status when the
update is complete.
• It is recommended to set the timed update to take place during the least active time period, for example
late at night.
This utility does not apply to CS programmes. These must be updated manually using the SD Card File View
and Load utility (see 2.6.4 Utility—SD Card File View and Load).
When this utility has been set, all commands that would affect the status of cards are prevented from operating.
The list of these commands is as follows:
• Card status change (INS/OUS)
• Diagnosis commands
• Card installation
• Card deletion
• Remote reset
• LPR programme download requests
• ISDN automatic setup requests (BRI card)
• Signalling Bit Monitor requests (T1/E1)
• Line trace start requests (T1/E1)
• ISDN/QSIG Protocol Data Trace start requests
• Time setting
• CS programme download requests
• File deletion
When a function other than those listed above, that cannot be performed while timed update has been set, is
selected, an error message will be displayed.
To turn this utility on:
1. From the Utility menu, select Card Software Timed Update.
2. Select the Set option.
The time setting box will become available.
3. Enter the desired time using the number keys.
Click in the hour or minute field and use the up and down arrows to adjust the displayed time in increments
of one unit.
4. Click Apply.
A message box will be displayed.
5. Click Yes.
To turn this utility off:
1. From the Utility menu, select Card Software Timed Update.
2. Select the Off (Cancel) option.
3. Click Apply.
A message box will be displayed.
4. Click Yes.
PC Programming Manual 87
2.6.20 Utility—Card Software Timed Update