Filter
Top Products
2.1.2 Access Levels
There are three main levels of access to the Maintenance Console: User, Administrator and Installer. Each
level has its own Programmer Code, which must be entered to run the Maintenance Console. The allowed
format for each programmer code is as follows:
Item Length
User Level Programmer Code 0 – 16 characters
Administrator Level Programmer Code 4 – 16 characters
Installer Level Programmer Code 4 – 16 characters
Access to menu options within the Maintenance Console is restricted depending on the Programmer Code,
and the current software mode (see 2.1.1 Starting Maintenance Console and Software Modes). When a
menu option is limited to certain access levels, this is noted in this manual in the initial description of that menu
option, for example:
"This option is only available at Installer level."
If a sentence like this does not appear under the heading, the menu option is available at all levels.
The target users for each access level are as follows:
Access Level User
User For end users
Administrator For system administrators
Installer For dealers and system installers
The options available in each mode and access level are shown below.
The access levels are abbreviated as follows:
U: User; A: Administrator; I: Installer
A check mark indicates that the menu option is available for that access level.
Programme launcher
Menu Option
Batch Interactive
U A I U A I
New
ü ü
Open
ü ü ü ü ü ü
Connect—RS-232C
ü ü ü ü ü ü
Connect—USB
ü ü ü ü ü ü
Connect—LAN
ü ü ü ü ü ü
Connect—Modem
ü ü ü ü ü ü
Connect—ISDN Remote
ü ü ü ü ü ü
Connect—Profile Setup
ü ü ü ü ü ü
PC Programming Manual 27
2.1.2 Access Levels