Filter
Top Products
A
• Perform the following steps:
1. Confirm that the Numbering Plan you will change is not currently being used by
any extensions (see 2.5.8 Tool—Extension List View).
If it is being used by extensions, temporarily change the extension numbers of
those extensions to that of another numbering plan, or delete the extension
number (see 6.1 [4-1-1] Wired Extension—Extension Settings and
6.10 [4-2-1] Portable Station—Extension Settings).
2. Clear the
Leading Number cell.
3. Click Apply.
4. Modify the No. of Additional Digits cell as required.
5. Click Apply.
6. Enter the desired value in the Leading Number cell.
7. Click Apply.
8. Set all extension ports to OUS status.
9. On the relevant screens, set the extension numbers of extensions to the desired
values.
10. Set all extension ports back to INS status.
Q When modifying the Numbering Plan, I cannot change the Leading Number.
A
• It
is not possible to use the same Leading Number for 2 extension blocks, or to use a
number that could possibly overlap with another Leading Number.
So, for example, if "2" is already set as a Leading Number it is not possible to set
"21" as another Leading Number because of the possible overlap of extension
numbers.
The number you are trying to store cannot be used if it is already being used by:
• A feature number
• Another extension block
• A Dial setting (see 11.1 [9-1] TIE Table)
• Quick Dialling (see 4.10 [2-6-2] Numbering Plan—Quick Dial)
In any of these cases, choose another number.
Q When modifying the Numbering Plan, how do I set a 1-digit extension number?
A
• Perform the following steps:
1. Clear the Leading Number cell.
2. Click Apply.
3. Set No. of Additional Digits to "None".
4. Click Apply.
5. Enter the desired value in the Leading Number cell.
6. Click Apply.
7. Set all extension ports to OUS status.
8. On the relevant screens, set the extension numbers of extensions to the desired
values.
9. Set all extension ports back to INS status.
Q How do I change a feature number?
A
• Perform the following steps:
1. Open the 4.9 [2-6-1] Numbering Plan—Main screen.
2. Change the value in the Dial cell of the desired feature.
3. Click Apply.
PC Programming Manual 93
2.7.1 Frequently Asked Questions (FAQ)