Filter
Top Products
Setting Features
Q How do I change the dialling mode of an analogue trunk?
A
• From
the 3.28
[1-1] Slot—Port Property - LCO Port screen, change the
Dialling
Mode setting of the target port to "DTMF" or "Pulse", as required.
Q How do I set disconnect detection (CPC Detection) for an analogue trunk?
A
• From the 3.28 [1-1] Slot—Port Property - LCO Port screen, modify the CPC
Signal Detection Time—Outgoing, Incoming setting of the target port.
The required value varies by carrier. Transmission and reception can be set
separately.
Q What settings do I change to enable use of an extension ISDN telephone?
A
• From the 3.31 [1-1] Slot—Port Property - BRI Port screen, set the Port Type of
the port you want to use to "Extension".
Q When using a TE with an extension ISDN, how do I enable power output?
A
• From the 3.31 [1-1] Slot—Port Property - BRI Port screen, set ISDN TE Power
on the ISDN Extension tab to "Enable".
Q How do I connect to another PBX using QSIG?
A
• From the 3.31 [1-1] Slot—Port Property - BRI Port or 3.33 [1-1] Slot—Port
Property -
PRI Port screen, set the
Port Type of the port you want to use to either
"QSIG-Slave" or "QSIG-Master".
Q
How do I change the type of an extension port?
A
• Set the port to OUS status. Then, change
DPT Type—Type in
the 3.24 [1-1] Slot
—Port Property - Extension Port window
Q I have set the type of an extension port to "DSS Console", but I cannot apply this
setting. (Error E000402)
A
• The number entered in
DPT Type—Location No. on the 3.24 [1-1] Slot—Port
Property - Extension Port screen is the same as that entered for another DSS
Console. Change this so that the numbers do not overlap.
Q I have set the type of an extension port to "VM (DPT)", but I cannot apply this setting.
(Error E000403)
A
• The DPT Type—VM Unit No. and DPT Type—VM Port No. settings entered on
the 3.24 [1-1] Slot—Port Property - Extension Port screen are the same as those
entered for another VM (DPT). Change this so that the numbers do not overlap.
Q I have set the type of an extension port to "PC Console", but I cannot apply this
setting. (Error E000402)
A
• The number entered in DPT Type—Location No. on the 3.24 [1-1] Slot—Port
Property -
Extension Port screen is the same as that entered for another PC Console.
Change this so that the numbers do not overlap.
96 PC Programming Manual
2.7.1 Frequently Asked Questions (FAQ)