Filter
Top Products
3.21 [1-1] Slot—Port Property - Virtual IPCS
Various settings can be programmed for each virtual IP-CS port.
To change the status of virtual IP-CS ports, click Command.
IP-CS Registration and De-registration
An IP-CS must be registered to the PBX by programming the PBX and IP-CS before it can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the IP-CS later.
Preparation
Open 3.4 [1-1] Slot—Card Property - IPCMPR, and confirm that the IP addresses of the IPCMPR and DSP
cards, subnet mask address, and default gateway address are set.
Registration
Follow the steps below to register the IP-CS.
1. Connect the IP-CS to be registered to the network and, if necessary, the power supply.
2. Click Registration.
A dialogue box will appear. Non-registered (available) IP-CSs are displayed on the left.
3. Highlight IP-CSs and click the right arrow to select them for registration. Click Next.
4. If the registration is still in progress, the dialogue box will show "Registration Executing
".
If the registration is successful, the dialogue box will show "Registration Completed". Click Close.
Once the IP-CS is successfully registered, the status of the IP-CS will update to show "Registered".
De-registration
Follow the steps below to de-register the IP-CS.
1. Click De-registration.
A dialogue box will appear. Registered IP-CSs are displayed on the left.
2. Highlight IP-CSs and click the right arrow to select them for de-registration. Click Next.
A dialogue box will appear.
3. Click Confirm.
• If the de-registration is successful, the dialogue box will show
"De-registration Succeed
".
• If the de-registration is unsuccessful, the dialogue box will show "De-registration Error".
De-registration will be terminated.
4. Click Close.
If the IP-CS is successfully de-registered, the status of the IP-CS will update to show "None".
Forced De-registration
Follow the steps below to forcibly de-register the IP-CS when normal de-registration has been unsuccessful
or IP address settings have been changed or deleted only on the IP-CS.
1. Click Forced De-registration.
A dialogue box will appear. Registered IP-CSs are displayed on the left.
2. Highlight IP-CSs and click the right arrow to select them for forced de-registration. Click Next.
A dialogue box will appear.
3. Click OK.
A dialogue box will appear.
PC Programming Manual 207
3.21 [1-1] Slot—Port Property - Virtual IPCS