Filter
Top Products
19
4 Basic Operation
5
Tighten the screw securely.
Tug the blade holder upward to make sure it does not
come loose.
Do not use excessive force when moving the sheet loading lever.
Doing so may damage it.
On the CX-24, use the control panel to choose the configuration of the loaded material.
On the CX-12, there is no menu for choosing the configuration of the material.
Screw
For more information about the range in which cutting is possible, see "9-2 About the Materials -
About the Cutting Area."
NOTICE
Acceptable Material Sizes
Width
(horizontal dimension)
Length
(vertical direction)
CX-24
50 to 700 mm (1-15/16 to 27-3/4 in.)
For flat material, 100 mm or more; for roll material,
no restriction
No other restrictions (* Accuracy assured within a
range of up to 1,600 mm (63 in.))
CX-12
50 to 395 mm (1-15/16 to 15-1/2 in.)
No restrictions (* Accuracy assured within a
range of up to 1,600 mm (63 in.))
4
While supporting the screw from below, insert into
the blade holder from above.
Insert until the collar of
the blade holder touches
the rim of the hole.
4-2 Loading the Material