Filter
Top Products
67
12 What to do if...
12-3 Uncut Areas Remain, or Areas Are Not Cleanly Cut
Are the blade and blade holder securely mounted?
Install these so that there is no looseness .
The blade may be broken.
Replace with a new blade.
Is there any buildup of dust or material adhesive on the tip of the blade?
Check if there are any dirty deposits on the blade. If dirty, remove and clean the blade.
Is there any buildup of pieces of material or dust inside the blade holder?
Take off the tip of the blade holder and remove any pieces of material inside.
Is the amount of blade extension correct?
If the setting for the amount of blade compensation is not correct for the blade, corners may be rounded or have horns.
Refer to "4-7 Performing a Cutting Test -
Adjusting the Amount of Blade Extension."
Are the blade force and cutting speed appropriate for the material being cut?
Perform a cutting test and use the display menu to make the settings for suitable values.
Refer to "4-7 Performing a Cutting Test -
Adjusting the Blade Force."
Is the blade protector damaged or deformed?
If material is not cut properly even though the CX-24/12 settings are correct and the blade and cutter holder are installed correctly, the
blade protector may be damaged. If this happens, contact your authorized Roland DG Corp. dealer or service center. (Replacement is a
charged service operation.)
12-4 The Results of Cutting Are Displaced, and Uncut
Portions Remain
Is a thick material being used?
When using a thick material, change the display menu setting from "WEIGHT" to "HEAVY."
When performing cutting using roll material, was the amount of material to be cut pulled out before performing cutting.
When the material is pulled out while cutting is being performed, the material may slip or operation may stop due to a motor error.