Filter
Top Products
23
4 Basic Operation
2
1
2
Making Menu Settings with the Control Panel
The width of the material is detected and the unit is
made ready for cutting.
* When flat material is loaded, the material moves
to the front and rear to detect the length of the
material as well.
At this time, if the material is crooked and looks
like it might come loose from the pinch rollers, or
actually does come loose, reload the material.
Press the [ENTER] key.
The cutting carriage starts to move.
How to View the Display
Press the [MENU/PARAM] key to change the
location of the cursor.
This is the menu item.
When the cursor is on the left
side, turning the dial cycles
through the menu items.
This is the setting value for the menu item
appearing on the left side.
When the cursor is on the right side, turning the dial
changes the setting value. Press the [ENTER] key to
confirm the setting.
For the CX-12:
The width of the material is detected and the unit is
made ready for cutting.
SETUP -> ENTER
OFFSET| <0.250>