Filter
Top Products
53
9 About the Blades and Materials
The cutting area along the horizontal plane (the direction in which the tool carriage moves) is determined by the position of the pinch
rollers. The workable area spans the length between the two rollers, minus a margin of about 1 mm (about 0.04 in.) on both sides.
If you selected [PIECE] on the CX-24, then when the length of the material is 1,600 mm (63 in.) or more, the CX-24 determines it to be
roll material, and sets the length at 24,998 mm (984-1/8 in.).
About the Cutting Area
Pinch roller (Right) Pinch roller (Right)
Cutting Area
Material
Pinch roller (Left)
About 1 mm
(about 0.04
in.)
Initial cutting coordi-
nate origin point (0,0)
About 15 mm (about 9/16 in.)
Max.
584 mm (23 in.)
Max.
280 mm (11 in.)
Max.24,998 mm (984-1/8 in.)
(Accuracy assured within a range of
up to 1,600 mm (63 in.))
Max. 24,998 mm (984-1/8 in.)
(Accuracy assured within a range of
up to 1,600 mm (63 in.))
<CX-24> <CX-12>
When Loading Flat Material
When you're using flat material, material that is at least 70 mm (2-13/16 in.) longer than the vertical size of the cutting data is required.
This is the length required for the pinch rollers to feed out the material to the front and rear. Refer to the figure below and ensure margins
at the front and rear of the material.
Pinch roller
20 mm
(13/16 in.)
50 mm
(2 in.)