Filter
Top Products
65
12 What to do if...
1
2
12 What to Do If...
12-1 If the CX-24/12 Doesn't Run...
Is the CX-24/12 power on?
Turn on the power.
Is the CX-24/12 in the setup state?
When the display shows the following message, cutting cannot be performed even when data is sent. When you enable the setup state,
cutting starts.
CX-24 CX-12
Has operation been paused?
When the following message appears, operation is paused.
To resume cutting, press the [ENTER] key.
If connected via the serial port, do the communication parameters for the CX-24/12 match those of the computer?
Use the display menu to set communication parameters for the CX-24/12 that match the communication parameters for the computer.
Is the computer set up correctly?
Refer to the documentation for the computer you're using and make the correct settings for the memory switches, interface board, and
other communication parameters.
Is the cable used for the connection to the computer connected correctly?
Check the output ports on the CX-24/12 and the computer and reconnect correctly.
Are the computer and the CX-24/12 linked with the right cable?
The type of cable you need is determined by your computer and the program you are using. Even if the computer is the same, running
different program may require a different cable. Use the cable specified in your program.
Are the program settings correct? (Using with MS-DOS.)
Specified output device (Select a model name that matches the instruction set. If the instruction set is different, completely different
instructions may be sent, resulting in an error.)
Refer to the documentation for the program and make the correct settings for the communication parameters and other values.
SELECT | ROLL SETUP -> ENTER
PAUSE | <CONT>
To stop operation
Halt transmission of cutting instructions from the
computer.
Turn the dial to display the screen shown at right,
then press the [ENTER] key.
PAUSE | <STOP>
Choose the loaded material, then press the [ENTER]
key to enable the setup state.
Press the [ENTER] key to enable the setup state.