Filter
Top Products
26
4 Basic Operation
1
2
3
Location of the origin point
- Near the left pinch roller
- Near the right pinch roller when the [ROTATE] menu
item is set to ON
- At the front lower left of the material
- Near the front lower right of the material when the
[ROTATE] menu item is set to ON
- Near the left pinch roller
- Near the right pinch roller when the [ROTATE] menu
item is set to ON
Material shape selected from the menu
[ROLL]
[EDGE]
[PIECE]
There is no material-selection menu.
CX-24/12, in addition to the foregoing locations, you can freely set the origin point (0, 0) anywhere in the cutting area.
Setting the origin point at an uncut area of the material lets you use the material with less waste.
To set the origin point where you want, follow the steps below.
Before setting the origin point, load the material.
Refer to "4-2 Loading the Material" and load the
material.
Use the position keys to move the center of the blade
holder to the location where you want to set the origin
point.
Press the [ORIGIN] key. The message [ORIGIN
SETTING] flashes on the display, and the origin point
is set.
Model
CX-24
CX-12
4-6 Setting the Origin Point
Loading material and pressing the [ENTER] key automatically sets the origin point for cutting.
The origin point set when you do this varies according to model and the shape of the selected material.
ORIGIN SET