Filter
Top Products
8 Cutting Printed Material
50
Are the layout locations for the marks correct?
Refer to "8-2 Shape and Layout of Crop Marks" to lay out the crop marks correctly.
Even when the laid-out locations in the program are correct, output at the correct locations is not
possible if [ROTATE] is set to [ON] for the CAMM-1 driver and at the CX-24/12's menu.
Enlarging or reducing the size during printing makes the locations where crop marks are output
misaligned.
MARK 2 NOT FOUND
MARK 2
Is the material loaded at an angle?
Are the printing results crooked?
Crop marks cannot be detected when the angle of a line connecting the
centerpoints of mark 1 and mark 2 is slanted by 5 degrees or more or
is misaligned by 15 mm or more in the material-feed direction.
Check the printing results and load the material correctly, referring to
"8-3 Loading the Material."
Do the distances between crop marks specified by the program
match the distances specified on the CX-24/12?
Make sure the distances between crop marks set in the program and on
the CX-24/12 are identical.
MARK 3 NOT FOUND
Are the crop marks laid out at the correct locations?
If the angle formed by the two lines connecting the centerpoints of the
three crop marks is not 90 degree, the crop marks cannot be read.
Crop marks cannot be read if the distance between crop marks in the
material-feed direction is 500 mm or more.
Refer to "8-2 Shape and Layout of Crop Marks" to lay out the crop
marks correctly.
MARK 3
8-6 When the Printing and Cutting Locations Are
Misaligned
When the locations of printing and cutting are misaligned even though detection of crop marks by the CX-24/12 ended correctly, one of
the following may be the cause.
Was an origin point specified in the program when outputting the data to the CX-24/12?
The origin points specified with the program are different during printing and during cutting.
Refer to "8-4 Performing Operations Using Crop Marks - Performing Cutting with the CX-24/12" and align the locations of the origin
points specified with the CX-24/12 before you send the cutting data.
Was the size aspect changed between printing and cutting?
Enlarging or reducing the size when printing or when cutting makes it impossible for the crop marks to be read.
Perform output at a size identical to the size of the design.
MEDIA MISALIGN
ANGLE TOO BIG
WIDTH TOO BIG
ANGLE TOO BIG
Is the cutting carriage exposed to direct sunlight or intense indoor lighting?
If the sensors on the cutting carriage are exposed to direct sunlight or indoor lighting, crop marks may
fail to be detected.
Install the machine where it is not exposed to direct sunlight or indoor lighting.