Filter
Top Products
56
10 Display Menu Descriptions
CROPMARK| <OFF>
Stored in Memory
Factory Default
Selection Choices
Description
CROPMARK
BASE X | <5mm>
Stored in Memory
Factory Default
Setting Range
Description
BASE X
Steps
BASE Y | <5mm>
Stored in Memory
Factory Default
Setting Range
Description
BASE Y
Steps
Yes
OFF
OFF, AUTO
This menu sets whether crop marks are read or not.
The detailed instructions for cutting by using crop marks are in "8
Cutting Printed Material" .
OFF:
Select this when you perform cutting only. The CX-24/12 doesn’t
read the crop marks.
AUTO:
The three crop marks are read automatically. This makes the
correction of width, length, angle and the location of the origin
point.
Yes
5 mm
0 to 50 mm
0.1 mm
This specifies the distance in x-direction between the
center of a crop mark and the origin point. Set the value to
the radius of the crop marks specified by the program.
Yes
5 mm
0 to 50 mm
0.1 mm
This specifies the distance in y-direction between
the center of a crop mark and the origin point. Set
the value to the radius of the crop marks specified
by the program.