Filter
Top Products
68
12 What to do if...
12-5 Error Messages
The location of one or more of the pinch rollers is not correct.
Press the [ENTER] key to clear the error.
Position the pinch rollers appropriately over the grit rollers and
reload the material.
Refer to "4-2 Loading the Material."
If this message appears even when you have moved the pinch rollers
to appropriate locations, the CX-24/12 may be exposed to direct sun-
light or strong indoor lighting.
To correct this, switch off the power and move the CX-24/12 to a
location that is not exposed to strong light.
After moving the unit, switch the power back on.
When the machine was put into the setup state, no material
was loaded.
The material was removed when the machine was in the setup state.
The material came loose during cutting.
Load the material, then put the machine in the setup state.
Press the [ENTER] key to clear the error.
Refer to "4-2 Loading the Material."
When [REPLOT] was executed, the amount of data sent from
the computer exceeded the buffer size of the CX-24/12.
Reduce the amount of data, then execute [REPLOT].
Refer to "7 Repeating the Same Cutting."
[REPLOT] was executed when there was no data in the
buffer.
Send the data from the computer, then execute [REPLOT].
Refer to "7 Repeating the Same Cutting."
Err:Bad Positin
SHEET UNLOADED
DATA OVERFLOW
DATA EMPTY
Origin Error
The CX-24/12 is exposed to direct sunlight or strong indoor light-
ing, and was not able to perform origin detection immediately
after the power was switched on.
To correct this, switch off the power and move the CX-24/12 to a
location that is not exposed to strong light. Then switch on the power
again.
About the error messages displayed when reading crop marks, refer to "8-5 When Crop Marks Cannot Be Read".