Filter
Top Products
69
12 What to do if...
Meaning
Appears if a framing error, parity error, or overrun error occurs at
the time of data reception. The protocol settings for the CX-24/12
must be made correctly in order to match the settings your computer
is set to use.)
Meaning
Appears if the I/O buffer has overflowed. There is a problem with
the connecting cable, or the settings for Handshaking. Make sure
you are using a cable appropriate for the computer being used. Also,
check that the setting for Handshaking is correct.
Meaning
This appears if an unspecified communication error other than
communication-related errors 10 through 16 occurs.
Er15:RS-232Err
Er16:BufferFlow
Er18:Ind.Error
The following error messages are displayed for informational purposes when the data described in "Details" is sent. When one of these
error messages appears on the display, sending of data stops and you are not allowed to perform the next operation.
Press the [ENTER] key to clear the error from the display.
Note that even after you clear the error message, the CX-24/12 retains in memory the fact that the error occurred, and so correct cutting
may not be possible even if data continues to be sent. To cancel the error, switch the power off and back on.
Meaning
Appears if an instruction that the CX-24/12 cannot interpret is sent.
Meaning
Appears if the number of parameters differs from the permissible
number.
Meaning
Appears if the value specified for a parameter is out of the permis-
sible range.
Er1:Wrong CMD.
Er2:Wrong No.s
Er3:Out of Range