Filter
Top Products
4–4 Start–Up and Operation MN735
Power Up On initial power–up, the drive is in Local control mode and the keypad will
display the Local Setpoint.
.
All parameters are at factory settings. Any changes to these conditions are
automatically saved. The drive will initialize on subsequent power–ups with
the previously saved settings and control mode.
How to Change a Parameter Value
You can change the values of parameters stored in the and
menus. Refer to “Parameter Definitions” for further information.
• View the parameter to be edited and press
to display the
parameter’s value.
• Select the digit to be changed (pressing the
key moves the
cursor from right to left).
• Use the
keys to adjust the value. Hold the key momentarily
to adjust the value marginally, or hold the key to make rapid changes;
the rate of change varies with the time held.
• Press
to return to the parameter display. The new value is
stored.
Special Menu Features
Reset to Factory Settings (2 button Reset)
HOLD
Then press
Turn power on while pressing the Y
and B keys. This loads or restores
the factory settings and application 1.
Select Local or Remote
Remote Control Mode: Allows control using digital and analog inputs and
outputs. Local control keys are inactive when Remote control mode is
selected. In remote mode, the control uses a remote setpoint (analog
Input 1).
Local Control Mode: Provides local control and monitoring of the drive
using the keypad. In local mode, the control uses the local setpoint
parameter (value is adjusted using the keypad).
Note: You can only change between Local and Remote control when the Inverter
is “stopped”, and either
or the Local Setpoint is displayed.
Remote to Local
Note: For safety reasons, the control will not return to Remote mode if this will
cause the drive to start. Verify that the RUN and JOG inputs are low.