Filter
Top Products
4–14 Start–Up and Operation MN735
Routine Maintenance
Periodically inspect the Inverter for build–up of dust or obstructions that
may affect cooling. Remove any build–up using dry air.
Saving Your Application Data
In the event of a repair, application data will be saved whenever possible.
However, you should record your application settings before returning the
unit. You should actually record the settings after programming. When a
failure occurs, you may not be able to access the parameter values.
Contact Baldor to arrange for the repair.
Disposal This product contains materials which are consignable waste under the
Special Waste Regulations 1996 which complies with the EC Hazardous
Waste Directive – Directive 91/689/EEC. We recommend you dispose of
the appropriate materials in accordance with the valid environmental control
laws. The following table shows which materials can be recycled and which
have to be disposed of in a special way.
Material
Recycle Disposal
metal yes no
plastic materials yes no
printed circuit board no yes
The printed circuit board should be disposed of in one of two ways:
1. High temperature incineration (minimum temperature 1200_C) by an
incinerator authorized under parts A or B of the Environmental
Protection Act.
2. Disposal in an engineered land fill site that is licensed to take
aluminium electrolytic capacitors. Do not dispose of in a land fill site
set aside for domestic waste.
Packaging
During transport our products are protected by suitable packaging. This is
entirely environmentally compatible and should be taken for central
disposal as secondary raw material.