Filter
Top Products
Appendix B
CE Guidelines
CE Guidelines B–1MN735
CE Declaration of Conformity
Baldor indicates that the products are only components and not ready for
immediate or instant use within the meaning of “Safety law of appliance”,
“EMC Law” or “Machine directive”.
The final mode of operation is defined only after installation into the user’s
equipment. It is the responsibility of the user to verify compliance.
The product conforms with the following standards:
DIN VDE 0160 / 05.88 Electronic equipment for use in
electrical power installations
DIN VDE 0100 Erection of power installations with
nominal voltages up to 1000V
DIN IEC 326 Teil 1 / 10.90 Design and use of printed boards
DIN VDE 0110Teil 1-2 / 01.89 Dimensioning of clearance and
creepage
DIN VDE 0110Teil 20 / 08.90 distances
EN 60529 / 10.91 Degrees of protection provided by
enclosures
EMC – Conformity and CE – Marking
The information contained herein is for your guidance only and does not
guarantee that the installation will meet the requirements of the council
directive 89/336/EEC.
The purpose of the EEC directives is to state a minimum technical
requirement common to all the member states within the European Union.
In turn, these minimum technical requirements are intended to enhance the
levels of safety both directly and indirectly.
Council directive 89/336/EEC relating to Electro Magnetic Compliance
(EMC) indicates that it is the responsibility of the system integrator to
ensure that the entire system complies with all relative directives at the time
of installing into service.
Motors and controls are used as components of a system, per the EMC
directive. Hence all components, installation of the components,
interconnection between components, and shielding and grounding of the
system as a whole determines EMC compliance.
The CE mark does not inform the purchaser which directive the product
complies with. It rests upon the manufacturer or his authorized
representative to ensure the item in question complies fully with all the
relative directives in force at the time of installing into service, in the same
way as the system integrator previously mentioned. Remember, it is the
instructions of installation and use, coupled with the product, that comply
with the directive.
Wiring of Shielded (Screened) Cables
Conductive
Clamp
Remove the outer insulation
to expose the overall screen.
500mm max.<30mm
<30mm