Filter
Top Products
4-18
Cisco ASA 5500-X Series Hardware Installation Guide
Chapter 4 Maintenance and Upgrade Procedures for the ASA 5500-X
Removing and Installing the Power Supply
Figure 4-23 Ground Wires
Figure 4-24 shows the DC power supply with lead wires.
Figure 4-24 DC Power Supply with Lead Wires
Step 7
Insert the exposed end of one of the ground wires into the inlet on the DC power supply. After you push
in the wires, they are held in place with a spring, which makes the physical contact. Make sure that you
cannot see any wire lead. Only wires with insulation should extend from the DC power supply.
Step 8 Repeat Step 5 through Step 7 for the remaining two DC input power source wires, the positive lead wire
and the negative lead wire.
1 Negative (–) lead wire 2 Ground lead wire
3 Positive (+) lead wire
333057
1
2
3
333060