Filter
Top Products
4-10
Section 4 APPLICATION SETTING EXAMPLES
ZS-MDC
User’s Manual
Section 4
Measuring Flatness
Measuring Flatness
This is an example of how to measure the height at 9 locations on a workpiece, and
calculate the difference (max. value - min. value) between each measured point. [MAX-
MIN] is used as the operation mode.
For details on how to connect and install the Sensor Heads and Sensor Controllers, refer to the “ZS-L
User’s Manual”.
FUN Mode-[SENSING]-[SEL CH]
1. Assign the CH No. of the controller to inputs
A to I to be used for the expression.
INPUT A: 1CH
INPUT B: 2CH
INPUT C: 3CH
INPUT D: 4CH
INPUT E: 5CH
INPUT F : 6CH
INPUT G: 7CH
INPUT H: 8CH
INPUT I : 9CH
Input A Input B Input C
Input I
CH0 CH1 CH2 CH9CH3
Input A Input B Input C Input I
The operation and/or measurement results are output
as judgement output or linear output.
▲
1INPUT A
3INPUT C
2INPUT B