Filter
Top Products
GEK–91584D, Vertical Drilling Motor, Type GE752
26
REF DESCRIPTION REF DESCRIPTION REF DESCRIPTION
4 CLAMP PLATE 17 CLAMP 21 STUD
5 BOLT 18 RING 22 STUD
6 PRESSURE CAP 19 CLAMP 23 NUT, 7/16–14
12 NUT, 5/8–11 20 STUD
FIG. 17. PULLER TOOLS. E–18155A.
framehead, jack the drive–end framehead loose,
and lift the complete armature assembly out of
the frame. DO NOT DAMAGE THE COMMUTA-
TOR.
13. Move the armature to a suitable fixture for further
bearing disassembly or repair.
14. Install puller (Part 6751547G4) and pull sleeve
(47) from the shaft at the drive end. Heat may be
applied.
15. Remove bolts and lockwashers (53) from bear-
ing cap (5). Remove the bearing cap and gasket
(54).