Filter
Top Products
Adding Signal Conditioning Components/Current Shunts
The multiplexer module’s terminal module allows you to add components
on each channel for the following:
– Low-Pass Filters
– Attenuators
– Current Shunts (for current measurements using a voltmeter)
Figure 2-8 shows how to install the appropriate components for the above
configurations. In the figure, channel 12 shows a low pass filter
configuration, channel 07 an attenuator configuration, and channel 04 a
current shunt configuration.
Figure 2-8. Signal Conditioning Components/Current Shunts
Chapter 2 Configuring the HP E1351A/53A FET Multiplexer Modules 23