Filter
Top Products
Command Quick Reference
The following tables summarize SCPI and IEEE 488.2 Common (*)
Commands for the 16-Channel FET Multiplexer Modules.
SCPI Commands Quick Reference
Command Description
ABORt Abort a scan in progress.
ARM :COUNt <
number> MIN | MAX
:COUNt? [MIN | MAX]
Multiple scans per INIT command.
Query number of scans.
DISPlay :MONitor:CARD <
number> | AUTO
:MONitor[:STATe] <
mode>
Selects module to be monitored.
Selects monitor mode.
INITiate :CONTinuous <
mode>
:CONTinuous?
[:IMMediate]
Enables/disables continuous scanning.
Query mode.
Starts a scanning cycle.
OUTPut [:STATe] <
state>
[:STATe]?
Enables/disables "Trig Out" pulse.
Query state of trig out pulse.
[ROUTe:] CLOSe <
channel _list>
CLOSe? <
channel _list>
OPEN <
channel _list>
OPEN? <
channel _list>
SCAN <
channel _list>
SCAN:MODE NONE | VOLT | RES | FRES
SCAN:MODE?
SCAN:PORT NONE | ABUS
SCAN:PORT?
SETTling[:TIME] <
channel_list>
SETTling[:TIME]? [MIN | MAX] <
channel_list>
Close channel(s).
Query channel(s) closed.
Open channel(s).
Query channel(s) opened.
Define channels for scanning.
Selects appropriate tree Isolation switches for measurements.
Query state of scan mode.
Enables tree isolation switches closure as part of a
measurement.
Query analog bus state.
Sets delay between trigger pulse and channel closed pulse.
Returns current parameter in SETTling[:TIME].
STATus :OPERation:ENABle
:OPERation[:EVENt]?
Enables the Operation Status Register to set a bit in the
Status Register.
Returns status of Operation Status Register.
SYSTem :CDEScription? <
number>
:CPON <
number> | ALL
:CTYPe? <
number>
:ERRor?
Returns description of module in a switchbox.
Sets specified module to its power-on state.
Returns the module type.
Returns error number/message in a switchbox error queue.
TRIGger [:IMMediate]
:SOURce BUS
:SOURce DBUS
:SOURce EXTernal
:SOURce HOLD
:SOURce IMMediate
:SOURce?
Causes a trigger to occur.
Trigger source is *TRG.
Trigger source is Digital Bus.
Trigger source is "Event In" port.
Hold off triggering.
Continuous (internal) triggers.
Query scan trigger source.
IEEE 488.2 Common Commands Quick Reference
Command Title Description
*RST Reset Opens all channels and invalidates current channel list for scanning.
Sets ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
*TRG Bus Trigger When scan is enabled and trigger source is TRIG:SOUR BUS, use the *TRG
command to trigger the switchbox to advance the scan.
*TST? Self-Test Power on interrupt returns +110.
Incorrect MFR ID or model code returns +103.
Test pass returns 0.
Chapter 5 HP E1351A/53A 16-Channel FET Multiplexer Command Reference 77