Filter
Top Products
Appendix C
HP E1351A/53A FET Multiplexer Error
Messages
Table C-1 lists the error messages associated with the multiplexer modules
programmed with SCPI commands. See the HP E1406A Command Module
User’s Manual for complete information on error messages.
Table C-1. 16-Channel FET Multiplexer Error Messages
No. Title Potential Causes
–211 Trigger Ignored Trigger received when scan not enabled. Trigger received after scan
complete. Trigger too fast.
–213 INIT Ignored Attempting to execute an INIT command when a scan is already in
progress.
–224 Illegal Parameter Value Attempting to execute a command with a parameter not applicable to the
command.
1500 External Trigger Source Already
Allocated
Assigning an external trigger source to a switchbox when the trigger
source has already been assigned to another switchbox.
2000 Invalid Card Number Addressing a module (card) in a switchbox that is not part of the
switchbox.
2001 Invalid Channel Number Attempting to address a channel of a module in a switchbox that is not
supported by the module (for example, ch. 99 of multiplexer module).
2006 Command Not Supported On
This Card
Sending a command to a module (card) in a switchbox that is
unsupported by the module.
2008 Scan List Not Initialized Executing a Scan without the INIT command.
2009 Too Many Channels in Channel
List
Attempting to address more channels than available in the switchbox.
2010 Scan Mode Not Allowed On
Thi
s
Card.
Attempting to execute a SCAN:MODE which is not supported.
2011 Empty Channel List
No valid channels in
<channel_list>.
2012 Invalid Channel Range
Invalid channel(s) specified in SCAN <
channel_list> command.
Attempting to begin scanning when no valid channel list is defined.
2017 Incorrect ARM:COUNt Attempting to run a downloaded scan list with ARM:COUNt set to value
other than 1.
2600 Function Not Supported On
This Card
Sending a command to a module (card) in a switchbox that is not
supported by the module or switchbox.
2601 Channel List Required Sending a command requiring a channel list without the channel list.
Appendix C HP E1351A/53A FET Multiplexer Error Messages 99