Filter
Top Products
OUTPut
The OUTPut subsystem enables or disables the "Trig Out" port of the HP
E1300/E1301 Mainframe.
Subsystem Syntax OUTPut
[:STATe] <
state>
[:STATe]?
[:STATe] OUTPut[:STATe] <state> enables/disables the "Trig Out" port on the rear
panel of the HP E1300/E1301 Mainframe.
OUTPut[:STATe] ON | 1 enables
the port and
OUTPut[:STATe] OFF | 0 disables the port.
Parameters
Parameter Name Parameter Type Range of Values
state
Boolean 0 | 1 | ON | OFF
Comments • Downloaded Scans: The OUTPut subsystem does not work with
downloaded scan lists. The scan list is downloaded automatically if
you use
TRIG:SOUR DBUS or TRIG:SOUR IMM (FET multiplexers
only).
OUTPut works with all other scanning methods.
• Enabling "Trig Out" Port: When enabled, the "Trig Out" port is
pulsed each time a channel is closed during scanning. When
disabled, the "Trig Out" port is not pulsed.
• Output Pulse: The pulse is a +5 V negative-going pulse.
• "Trig Out" Port Reserved by Switchboxes: The "Trig Out"
resource is a system resource, and can only be reserved by one
instrument at a time.
• Related Commands: [ROUTe:]SCAN, TRIGger:SOURce
• *RST Condition: OUTPut[:STATe] OFF (port disabled)
Example Enabling "Trig Out" Port
OUTP ON Enables "Trig Out" port for pulse
output.
[:STATe]? OUTPut[:STATe]? queries the present state of the "Trig Out" port. The
command returns 1 if the port is enabled, or 0 if disabled.
Example Query "Trig Out" Port State
OUTP ON Enables "Trig Out" port for pulse
output.
OUTP:STAT? Query port enable state.
62 HP E1351A/53A 16-Channel FET Multiplexer Command Reference Chapter 5