Filter
Top Products
Multiplexer Commands
The following commands are covered in Chapter 3. For a complete list and
description of commands see Chapter 5, “Command Reference”.
Table 3-1. Matrix Commands Used in Chapter 3
Command Description
ARM:COUNt <
number> Selects number of scanning cycles for a switchbox only. Does not
apply to downloaded scan lists.
INITiate[:IMMediate]
INITiate:CONTinuous <
mode>
<
mode> = 1 | 0 | ON | OFF
Channel advance for TRIGger:SOURce BUS | HOLD.
Enables/disables continuous scanning cycles.
[ROUTe:]CLOSe <
channel_list>
[ROUTe:]CLOSe? <
channel_list>
Closes specified channels.
Queries mainframe for channel closure.
[ROUTe:]OPEN <
channel_list>
Opens specified channels.
[ROUTe:]SCAN <
channel_list>
Closes all channels in channel list one at a time. Previous channel
opens before next channel closes.
[ROUTe:]SCAN:MODE FRES Closes paired channel relays (for example, channels 01 and 09)
during 4-wire ohms measurements.
[ROUTe:]SCAN:PORT ABUS Automatically closes the tree isolation switches.
TRIGger[:IMMediate]
TRIGger:SOURce <
source>
<
source> = EXT | BUS | DBUS | IMM
Channel advance for TRIGger:SOURce BUS | HOLD.
Selects the trigger source as EXTernal, HP-IB BUS, Digital BUS,
or IMMediate.
NOTE: The commands with brackets ([ ]) are implied and are not shown in this chapter.
Chapter 3 Using the HP E1351A/53A FET Multiplexer Modules 31