Filter
Top Products
FIRING BOARD
G3742-[ ]
LED7
LED8
LED9
LED1
LED2
LED3
LED4
LED5
LED6
LED10
J5
J6
J7
J4
J8
(205) 8
(206) 7
(207) 6
(208) 5
4
3
2
1
16 (204)
15 (203)
14
13 (231)
12 (215)
11
10
9
FIGURE F.6 FIRING BOARD
FIRING BOARD TEST (continued)
PROCEDURE
ELECTRIC SHOCK
can kill.
• Do not touch electrically hot parts.
1. Disconnect the AC input power to the DC-600
machine.
2. Locate the firing board on the left side of the con-
trol box.
3. Perform a visual inspection on the firing board to
see if there are any loose or faulty connections or
physical damage.
4. Connect the correct AC input power to the DC-600.
5. Turn the power switch (SW1) to the ON position.
6. LEDs 7, 8 and 9 should be lit and equally bright.
See Figure F.4 to locate the LEDs. The three LEDs
should be of equal intensity. If not correvt, see the
PC Board Troubleshooting Guide.
7. Trigger the DC-600 using the Output Terninal
Switch and see that LEDs 1 thru 6 and LED 10
come on.
NOTE: LEDs 1 thru 6 should alwaysl be the same bril-
liance as each other. The brilliance will vary as
the Output Control is changed.
8. If LED 10 does not come ON, perform the Internal
Trigger Test.
9. If LEDs 7,8 &9 are ON and any of LEDs 1 thru 6
are not ON, turn the machine OFF , disconnect J4
and re- energize the machine. All six LEDs should
be ON very bright. If not Replace the Firing Board.
If so perform the SCR Bridge Test.
10. If LEDs 7,8 &9 are ON and any of LEDs 1 thru 6
are not the same briliance as the others, Perform
the SCR Bribge Test. If OK, replace the Firing
Board.
11. If LEDs 1 thru 6 do not change as the output con-
trol is varied:
• Check the Output Control Potentiometer.
• Make sure that the Local/Remote Switch is in
Local and functioning properly.
• Perform the Control Board Test. If OK, replace
the Firing Board
TROUBLESHOOTING AND REPAIR
F-18 F-18
DC-600
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
WARNING