Filter
Top Products
TROUBLESHOOTING AND REPAIR
F-66 F-66
CLASSIC® 300D & 300G
ALTERNATOR ROTOR REMOVAL
AND REPLACEMENT PROCEDURE (continued)
FIGURE F.6 – ROTOR REMOVAL
STATOR
FRAME
NUT
SLEEVE
COLLAR
"BENT"
WASHER
BRUSH
HOLDER
ASSEMBLY
See Figure F.6 for steps 6 - 8.
6. With the 7/16" wrench, remove the two bolts,
nuts and washers mounting the brush holder
assembly to the stator frame.
7. Bend the flat washer away from the rotor lock-
ing nut.
8. With the 1-5/8" socket wrench, remove the
rotor locking nut, washer and sleeve collar.
NOTE: The sleeve collar will have to be
removed with a gear puller. Be careful
not to damage the rotor slip ring assem-
bly. Remove the rotor by pulling it free of
the generator shaft.
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC