Lincoln Electric SVM194-A Welder User Manual


 
INSTALLATION
A5.5 A5.5
CLASSIC® 300D & 300G
BATTERY CHARGING
The Classic® 300G is equipped with a wet charged
battery. The charging current is automatically regulated
when the battery is low (after starting the engine) to a
trickle current when the battery is fully charged.
When replacing, jumping or otherwise connecting the
battery to the battery cables, the proper polarity must
be observed. This system is NEGATIVE GROUND.
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes
away.
BATTERY ACID can burn eyes and
skin.
• Wear gloves and eye protection and
be careful when boosting, charging
or working near battery.
To prevent EXPLOSION when:
• Installing a new battery - disconnect the negative
cable from the old battery first and connect the
negative cable to the new battery last.
• Connecting a battery charger remove the battery
from the welder by disconnecting the negative
cable first, then the positive cable and battery
clamp. When reinstalling, connect the negative
cable last.
• Using a booster - connect the positive lead to the
battery first, then connect the negative lead to
the ground lead on the base.
To prevent ELECTRICAL DAMAGE when:
Installing a new battery.
Using a booster.
Use correct polarity - Negative Ground.
• To prevent BATTERY DISCHARGE, if you have an
ignition switch, turn it off when engine is not run-
ning.
• To prevent BATTERY BUCKLING, tighten nuts on
battery clamp until snug.
------------------------------------------------------------------------
WARNING
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC