Filter
Top Products
Control Panel
AWG5000 Series Quick Start User Manual
17
Run State Control and Output On/Off
Do the following steps to control the start and stop of signal generation for the arbitrary waveform generator.
Quick Tips
■ You can turn each channel’s output on/off independently.
■ Analog output and marker output are enabled or disabled simultaneously.
1. Use the front-panel Run button to start
and stop the signal generation.
Switching signal generation on or off is
called Run State control.
If the signal is being generated, the LED
indicator lights up.
2. To output the signal through the output
connectors, push the front-panel All
Outputs On/Off button or the Channel
Output On button.
3. Alternatively, you can use the Ch n
(Channel) tab on the Settings window to
enable the signal output. See page 26
for Settings Window.
1
2
3