Filter
Top Products
Interface and Display
26 AWG5000 Series Quick Start User Manual
Settings Window
Use the Settings window tabs to quickly access the Level (Ch 1, Ch 2, Ch 3, and Ch 4), Timing, Run Mode, Trigger, Event,
or DC Output parameters. You can also use the front-panel buttons for selecting frequently accessed parameters, such as
amplitude, offset, marker high/low, or sampling rate. See page 20 for details about accessing menus.
Channel (Ch n) Page
Quick Tips
■ Each channel has independent output on/off control. When the output status of Ch n is set to On, both analog output and
marker output are enabled.
■ When Direct Output is set to On, filter and offset settings become inactive. The analog bandwidth setting range will
change.
■ You can use Add Input when Direct Output is set to Off. If Direct Output is selected, Add Input is disabled.
■ For Waveform Rotation, see page 62.
1. To enable a channel output, click the
Output On button.
2. You can set parameters for amplitude,
offset, filter, and marker.
3. You can add an external signal to each
channel analog output.
4. Select Direct Output On and Off.
5. When the instrument is in the
non-sequence mode, you can select the
output waveform data using the Output
Waveform field. Click the waveform list
icon to display the Waveform List dialog
box.
6. You can set phase shift or delay for
each analog output signal when the
instrument is in the non-sequence
mode.
1
4
2
3
5
6