Filter
Top Products
Using the Edit Menu
AWG5000 Series Quick Start User Manual
43
6. Use Level to set parameters for Ampli-
tude/Offset or High/Low.
7. Use Option to select the amplitude/
offset settings. This frame is displayed
when you set the vertical units to
Voltage.
If you set the vertical units to Normal-
ized Value, this frame is disabled. Refer
to page 59 for vertical units setting.
8. Select an edit action in the Operation
frame.
■ Set to
Specifies the channel and index
number. The created waveform is
assigned to the specified position.
■ Insert before
The created waveform is inserted
before the specified cell of the
sequence. When this command is
executed, the remaining data is
shifted. When the Run mode is
non-sequence, this parameter is dis-
abled.
■ Create only
Creates a new waveform, but the
waveform is not loaded. Enter the
waveform name in the Waveform
Name box. The created waveform is
listed in the Waveform List window.
■ Overwrite
Specified existing waveform data is
overwritten. When you select Over-
write, a waveform currently being
loaded is displayed in the Target
Waveform Name box. The Waveform
Name box is disabled.
9. Click Execute to create a waveform.
8
6
7
9