Tektronix AWG5000 Series Welding System User Manual


 
Tu torials
AWG5000 Series Quick Start User Manual
71
Tu t o ri a l s
The examples in this section show how to use your instrument to do common arbitrary waveform generator tasks. These
examples use the dual-channel model.
Creating and Editing a Standard Waveform
1. Recall the default setup.
2. Select Continuous from the Run Mode
page of the Settings window.
3. Use the Standard Waveform dialog box
to create the square waveform shown
below:
Waveform Length: 960 points
Cycles: 5
Amplitude: 1.0 V
p-p
Offset: 0.5 V
4. Set the waveform created in step 3 to
Ch 1.
5. Assign the waveform name
“Ch1-Square” to the waveform.
6. Use the Standard Waveform dialog box
to create the sine waveform shown
below:
Waveform Length: 1024 points
Cycles: 3
Amplitude: 1.0 V
p-p
Offset: –0.5 V
1
2
3
4
5
6