Filter
Top Products
Using the System Menu
AWG5000 Series Quick Start User Manual
67
Using Force Jump To Dialog Box
Force Jump allows you to jump to a position that you choose. This function is used in sequence mode.
Quick Tips
■ The arbitrary waveform generator has an Event Jump function which changes the sequence using an event signal. Use
the Event page of the Settings window to set parameters for Event Jump. See page 31 for the Event page.
■ Use the Sequence Control Parameters dialog box from the Edit menu to set the jump target of Event Jump.
See page 46 for the dialog box.
■ Force Jump is similar to Event Jump. In the case of Force Jump, you must specify the jump target explicitly by using
the Force Jump To dialog box.
■ Force Jump is independent from Event Jump. Force Jump can be executed regardless of the Event Jump setting.
1. Select System > Force Jump To... to
open the Force Jump To dialog box.
2. Specify a jump target or select Index
No.
3. When Index No is selected as jump
target, enter the index number using the
Value: field.
4. Click Jump Now to change the wave-
form output to the position specified by
jump target.
5. Click Close to close the dialog box.
1
2
4
3
5