Filter
Top Products
Getting Started
VITS100 NTSC VITS Inserter Instruction Manual
1–5
You can mount the VITS inserter in a standard equipment rack or custom install
it. In custom installations, be sure to provide easy access to the signal-selection
DIP switches through the removeable panel in the top of the instrument. Also be
sure not to block the cooling holes in the top cover. After performing the
functional check, complete installation with the following steps:
1. If you wish, mount the VITS inserter in an existing equipment rack with one
of the following Tektronix generator mounting kits:
H TVGF11A—Single Rack Mount Adapter
H TVGF13—Dual Rack Adapter
H TVGF14—Dual Half-Rack Adapter
Please contact your nearest Tektronix representative or field office for more
information.
2. Connect the VITS inserter to your system as shown in Figure 1–2.
3. See the Operating Basics section of this manual for more information about
configuring and using the VITS inserter.
Program line OUT
Program line IN
Waveform monitor or
vector scope (optional)
Figure 1–2: A typical installation
Installation