Filter
Top Products
l <;<A.99<D3.:696.?6AF4.6;213?<:3?2>B2;A
B
@2 <3 F<B? :6A2? @.D A< /20<:2
0<::<;=9.02 Always remember that a careless
fraction of a second is sufficient to inflict severe
injury.
l THINK SAFETY! SAFETY IS A COMBINATION
OF OPERATOR’S COMMON SENSE,
KNOWLEDGE OF THE SAFETY AND
OPERATING INSTRUCTIONS AND
ALERTNESS AT ALL TIMES WHEN THE MITER
SAW IS BEING USED.
'*%""&&#*" #*
"#("#",#(%'##
'& *%""& % #" , #""&
#%!#'!#%' &', %( &
" $%('#"& '' $$% " ,#(%
#*"%N& !"( ', &%) &
%!"%# &',%( &"#%
&#$%'#"#'&!'%&*
&<:2 1B@A 0?2.A21 /F =<D2?
@
.;16;4@.D6;44?6;16;41?6996;4
.;1 <A52? 0<;@A?B0A6<; .0A6C6A62@ 0<;A.6;@
052:60.9@8;<D;A<0.B@20.;02?/6?A512320A@<?
<A52??2=?<1B0A6C25.?:&<:22E.:=92@<3A52@2
052:60.9@.?2
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other
masonry products, and
• Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well-ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter
out microscopic particles.
Do Not Carry the
Saw by this handle.
No lleve la sierra
por este mango.
Ne transportez pas la
scie par sa poignée.
DESIGNATED NO - CARRY
AREA - A DANGER ZONE -
NEVER LIFT OR CARRY
SAW BY THE MAIN SWITCH
HANDLE.
DESIGNATED PINCH POINT
AREA - A DANGER ZONE -
AVOID PLACING HANDS,
FINGERS OR ARMS IN THESE
AREAS. NEVER ATTEMPT TO
MOVE OR LIFT THE SAW IN
THESE AREAS.
DESIGNATED DANGER
ZONES - AVOID POSITIONING
HANDS, FINGERS OR ARMS
IN THE AREA DESIGNATED
BY THIS SYMBOL.
Safety
“READ ALL INSTRUCTIONS” — Failure to follow the SAFETY RULES identified by
BULLET (l) symbol listed BELOW, and other safety precautions, may result in serious
personal injury.
K&)'&"&'%('#"&L
*%""
!
*%""
!
*%""
!
Do not use the Bosch GCM12SD miter saw to cut fiber cement board. The Bosch miter saw is not
intended to cut fiber cement board.
*%""
!
BM 2610007877 04-10:BM 2610007877 04-10.qxp 4/26/10 8:13 AM Page 5