Filter
Top Products
'< .C<61 6;7B?F 3?<: .00612;A.9
@A.?A6;4?2:<C2=9B43?<:=<D2?
@<B?02<BA92A/23<?2:.86;4.;F.17B@A:2;A@
&D6A05 <08# %292.@2 BAA<;@ – One of
these two buttons must be pressed before the
power switch can be pressed.
$<D2?&D6A05 – The power switch used with the
“Lock-OFF” button energizes the unit.
!.6;.;192 – This handle contains the power
switch. Pulling this handle down lowers the blade
into the workpiece.
<D2? 9.12 B.?1 <D2? B.?1 6= – The
lower blade guard helps protect your hands from
the spinning blade. It retracts as the blade is
lowered. Lip can be used to raise the lower guard
in the event that the guard becomes jammed on
a workpiece.
9.12 – Use only 12" (308 mm) diameter blades
with 1" (25.4 mm) diameter arbor holes.
56= 23920A<? – Deflects cut-off workpieces
from entering the upper guard.
(==2? B.?1 – Covers upper portion of the
blade.
&9616;42;02 – Supports the workpiece. The
fence has a cast-in scale to make repetitive cuts
easy. The fence also has holes to secure an
auxiliary fence if desired.
&A.A6<;.?F2;02 – Stationary fence is bolted
to the base and will support the workpiece when
the sliding fence is removed.
2?3 ;@2?A@ – Kerf inserts can be adjusted to
different blade widths to minimize workpiece
tear-out.
!6A2?2A2;A#C2??612 – Allows detent action to
be locked out, allowing for micro-adjustments to
any miter angle.
!6A2? <08;</ – The miter lock knob locks the
miter saw table at any desired miter angle.
!6A2? 2A2;A 2C2? – The lever releases the
table from the detent.
2C29 <08 2C2? – The front-positioned bevel
lock lever locks the head assembly at the desired
bevel angle.
!6A2?&0.92!6A2?$<6;A2? – The pointer rotates
with the table and blade. It points to the miter
scale to indicate the angle setting before a cut is
made.
!6A2? 2A2;A $9.A2 – The position of the plate
can be adjusted to set the accuracy of its detent
locations.
!6A2?2A2;A@ – There are ten (10) miter detent
slots for fast and accurate miter cuts of common
miter angles.
'./92 – Sits in base, provides workpiece
support, rotates for desired miter cuts and
rotates the head assembly. The front extended
part of the table is called the miter arm.
.@2 – Provides working surface to support
workpiece.
'<<9!<B;A6;4$.1@ – The four corners of the
saw provide areas to clamp, bolt or nail the saw
to a flat work surface.
*%""
!
Getting To Know Your Miter Saw
1
1
4
5
6
2
3
3
1
8
9
10
11
15
13
12
14
18
19
20
21
22
17
16
8
23
29
28
30
9
24
27
25
26
7
BM 2610007877 04-10:BM 2610007877 04-10.qxp 4/26/10 8:13 AM Page 8