Emerson HASXEDE-IM-EX Welding Consumables User Manual


 
Emerson Process Management GmbH & Co. OHG5-2
X-STREAM XEFD
Instruction Manual
HASXEDE-IM-EX
03/2012
5.1 Dismounting & Disposal
When the instrument has reached the end of its useful life,
When the instrument has reached the end of its useful life, do not throw it in a
trash can!
This instrument has been made of materials to be recycled by recyclers spe-
cialised in this eld. Let the instrument and the packing material duly and envi-
ronmently friendly be disposed of. Ensure the equipment is free of dangerous
and harmful substances (decontaminated).
Take care of all local regulations for waste treatment.
Consider all instructions given in the X-STREAM XE instruction manual for
dismounting and disposal!
Advice concerning the disposal of batteries
This instrument contains a CR primary lithium button cell battery of size CR 2032.
The battery is soldered to an electronics board and usually does not need to be replaced
during the instrument´s lifetime.
At the end of lifetime, the instrument must be disposed in compliance with the wast regulati-
ons, see instructions below.
purge all gas lines with inert gas
ensure all gas lines are pressureless
disconnect all gas lines
switch off power and signal lines
disconnect and remove all electrical con-
nections
ll out the Declaration of Decontamination
( X-STREAM XE instruction manual)
properly
hand over the dismounted instrument to-
gether with the Declaration of Decontami-
nation to a disposal specialist. The dispo-
sal specialist then has to disassemble the
instrument, and recycle and dispose it and
the contained battery in compliance with
all applicable waste treatment regulations.
GASES HAZARDOUS TO HEALTH
Follow the safety precautions for all applied gases and gas cylinders.
Before opening the gas lines, they must be purged with air or neutral gas
(N2) to avoid danger from escaping toxic, ammable, explosive or hazardous
gases.