Emerson HASXEDE-IM-EX Welding Consumables User Manual


  Open as PDF
of 140
 
Emerson Process Management GmbH & Co. OHG TOC-1
X-STREAM XEFD
Instruction Manual
HASXEDE-IM-EX
03/2012
TOC
Table of contents
Table of ConTenTs
Introduction S-1
Denitions S-1
Terms used in this instruction manual .......................................... S-2
Symbols used on and inside the unit ........................................... S-3
Symbols used in this manual ................................................. S-4
Safety Instructions S-5
Intended Use Statement..................................................... S-5
General safety notice / Residual risk ........................................... S-5
Special Conditions for Safe Use............................................... S-5
Authorized personnel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . S-6
Additional Literature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . S-6
Chapter 1 Technical Description 1-1
1.1 Overview .............................................................1-1
1.2 Design Features........................................................1-1
1.3 Protective Measures in Detail .............................................1-2
1.4 High Pressure Option / Purge Option .......................................1-3
1.5 Explosion Protection Compliances .........................................1-4
1.5.1 Special Conditions for Safe Use ..........................................1-5
1.6 Nameplate Label .......................................................1-6
1.7 Technical Data .........................................................1-7
1.8 Measurements Specications ..........................................1-15
1.9 Vapor Recovery Application (Simultaneous Measurement of CH
4
and Non-CH
4
) .....1-19
Chapter 2 Installation 2-1
2.1 Scope of Supply........................................................2-1
2.2 Installing the Analyzer ...................................................2-2
2.3 Connecting Gas Lines ...................................................2-4
2.3.1 Special Conditions ....................................................2-5
2.3.2 Gas Conditioning...................................................2-7
2.4 Electrical Installation ....................................................2-8
2.4.1 Equipotential bonding conductor ........................................2-20
Chapter 3 Start up 3-1
3.1 Final Check ...........................................................3-1
3.2 Performing a Leak Test ..................................................3-2
3.3 Switching On ..........................................................3-3
3.4 Symbols and Typographical Conventions ....................................3-4
 previous next