Filter
Top Products
Emerson Process Management GmbH & Co. OHG3-10
X-STREAM XEFD
Instruction Manual
HASXEDE-IM-EX
03/2012
3.6 Software
Editing
The editing mode enables changing parame-
ters. It is initiated by pressing enter.
If the selection is a parameter list, the current
entry is highlighted and may be changed by
up and down.
If the selection is a value, the cursor is placed
over the last character. Use up and down to
change it.
Use left and right to select another character.
The type of available characters depends on
the position of the cursor:
• It is not possible to select the minus sign or
decimal point as the last character
.
• It is not possible to select the decimal point
in integer values
.
• For decimal numbers, the decimal point can
be placed anywhere within certain limits.
There are two ways to exit the data entry
mode:
enter: the entry is veried.If it is accepted,
it is saved and the new value dis-
played; if not, an error message is
displayed
.
home: Cancel: all settings and changes are
reset to their former values.
Component selection menu
Within the analyzer software, one can distin-
guish between analyzer related and compo-
nent related menus: While the rst contain
entries, relevant for the analyzer (e.g. time
setting), the second contain entries relevant
for a specic component (channel) only (e.g.
calibrating a channel).
For single channel analyzers, editing any
channel specic parameter will only effect
this one channel.
Different for multi-channel analyzers: Such
instruments require selecting a channel prior
to changing channel related parameters.
When a channel related menu entry is selec-
ted, automatically a SELECT COMPONENT
menu shows up, to select the component of
interest, or to cancel the current action.
Select the component / channel you want to
work with, and press enter.
This menu does not show on single-channel
units.
Within menu descriptions, the following points
out, that for multi-channel instruments a selec-
tion is required:
Select Component
Component: Ch1
Press
to return
Multi-channel unit:
In SELECT COMPONENT select the chan-
nel to be ...